English

@Speakers/SubwooferTo connect the speaker cords

•When connecting the speaker cords, match their polarity with that of the speaker terminals: red/blue to (+) and black to (–).

1

2

3 4

From right front main speaker

From left front main speaker

To remove the speaker grilles of the main speakers

Holes

Projection

Speaker grille

•The speaker bottom grille is not detachable. Do not try to remove it as this may damage it.

¤Surround speakers

From the right surround speaker (not supplied)

From the left surround speaker (not supplied)

From subwoofer

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the System.

•The front speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.

–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.

Then wait at least 30 minutes before turning on the TV’s main power switch again.

Some TVs may still be affected even though you have followed the above instruction. If this happens, move the speakers away from the TV.

•DO NOT connect more than one speaker to each terminal.

•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

#To adjust the voltage selector

Use a screwdriver to rotate the voltage selector so that the voltage mark is pointing at the same voltage as where you are plugging in the unit. (See also the back cover page.)

Voltage mark

DO NOT plug in before setting the voltage selector and all connection procedures are completed.

5