Names of parts and their functions (continued)
L
. P A G E | 2 |
G A M M A
E N H A N C E
A L C
L
. P A G E | 3 |
D . S H A D I N G |
|
N R |
|
M . B L A C K |
|
S Y N C |
|
H O U R M E T E R 0 0 0 3 H 5 4 M
[GAMMA] menu
Select a gamma correction or no gamma correction.
Selected item | Gamma |
0.43 | =0.43 |
0.45 | =0.45 |
0.47 | =0.47 |
0.49 | =0.49 |
OFF | No gamma correction =1.0 |
[ENHANCE] menu
Select the contour compensation value or
The leftmost on the minus side is the setting for
[ALC] menu
[ZONE] sub-menu
Change the size of the zone where automatic sensitiv- ity control and auto white level detection is performed. Select [FULL], [LARGE], [MEDIUM], or [SMALL] with [LEFT]/[RIGHT] button.
[DET] sub-menu
Select the level detection method for automatic sensitivity control from peak detection (P), average detection (A), or the combination of both. Use the [LEFT]/[RIGHT] button to select from 5 different levels. The far left is only for peak detection, while the far right is for average detection only. In between there are 3 levels for both peak and average detections.
[D.SHADING] menu
For correction of dynamic shading. (colour appearing on the screen in vertical direction.)
No correction at the centre. ± 7 levels of correction is possible.
[GREEN] sub-menu
Increase the green gain at the top of the screen by setting the + side. (Reducing the green gain at the bottom of the screen.)
Reduce the green gain at the top of the screen by setting the - side. (Increasing the green gain at the bottom of the screen.)
[RED] sub-menu
Increase the red gain at the top of the screen by setting the + side. (Reducing the red gain at the bottom of the screen.)
Reduce the red gain at the top of the screen by setting the - side. (Increasing the red gain at the bottom of the screen.)
[NR] menu
To set
HIGH : Large noise reduction effect. (In frequent moving ob- jects, the shadow may be obvious)
LOW : Suppressed noise reduction setting.
OFF : Noise reduction is OFF.
[M.BLACK] menu
Select the master black (setup) value. From the centre with no setup, change of ±3 steps each side at about 7% step is possible.
[SYNC] menu
Switching between sending GENLOCK basic signal, or input basic signal from other device.
[HOUR METER] display
Indicates accumulated time of power usage.
It cannot be selected with cursor.
16
