JVC FS-L30 manual Connecting Speakers, Turn the AM loop antenna until you have the best reception

English

AM antenna Connecting Speakers

ANTENNA

	Vinyl-covered wire
1	(not supplied)
	AM EXT
	AM LOOP
	FM 75
	COAXIAL

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM

LOOP terminals as illustrated.

• If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

1		2
		3
SPEAKERS	RIGHT	LEFT
Speaker cord		Speaker cord
SPEAKER
IMPEDANCE
MIN 6
Right speaker		Left speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord to the

terminal.

Match the polarity between the unit and the speaker terminals: (+) to (+) and (–) to (–).

•If cords are covered with insulation, twist the core of the cord at the end of each cord,

then remove the insulation.

3Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –