JVC FS-X1/FS-X3 Tone Control BASS/TREBLE, Auto Power Off A.P.off, No signal condition, Examples

Basic Operations

Tone Control (BASS/TREBLE)

You can control the tone by changing the bass (low frequen- cy) and treble (high frequency).

On the Remote Control

1 Press the BASS/TREBLE button.

Each time you press the button, the Tone Control mode changes as follows.

BASS = TREBLE = Normal display = (back to the begin- ning)

2 While “BASS” or “TREBLE” appears on the display, press the VOLUME + or - button to adjust the bass or treble level.

You can change the level within the range of -5 to +5. (0: flat)

3 Press the BASS/TREBLE button until normal display appears.

Waiting for five seconds will also return the System to the normal display.

Auto Power Off (A.P.off)

You can automatically turn off the System when no signal condition continues for three minutes. This function is ef- fective when the source is set to “CD”, but not to “FM”, “AM” or “ LINE”.

To Enable the A.P.off function (When the source is “CD”)

1 Press the A.P.off button on the Remote Control until “A.P.off SET” appears on the display.

Then, the “A.P.off” indicator lights up on the display.

•Each time you press the button, the display alternates as follows.

A.P.off SET Ô A.P.off STOP

When no signal condition is detected, the “A.P.off” indica- tor will start blinking soon.

No signal condition:

Source CD: CD is stopped or no CD is inserted.

When no signal condition continues, “A.P.off 20 sec” (20 seconds left before elapsed time reaches three minutes) ap- pears on the display. The displayed time is counted down and, finally, the System is turned off (Standby mode).

•If a CD is played back, the “A.P.off” indicator stops blinking and stays lit again.

•If you press a button or turn the VOLUME control, three-minute counting down is reset and counting down newly restarts.

To disable the A.P.off function

When the source is “CD”, press the A.P.off button on the Remote Control until “A.P.off STOP” appears on the dis- play.

Then, the “A.P.off” indicator goes out.

Entering the Number with the Remote Control (Numeric Keys)

You will use the Numeric Keys on the Remote Control to enter numbers for presetting stations, recalling the preset stations, selecting track number, or programming the play- ing tracks on a CD.

How to enter the number with the Numeric Keys is ex- plained here.

Examples:

•To enter number 5, press 5.

•To enter number 10, press 10.

•To enter number 15, press +10 then 5.

•To enter number 20, press +10 then 10.

•To enter number 25, press +10, +10, then 5.

12