JVC GET0425-001A manual A Typical connections, B Connecting the external amplifier or subwoofer

ELECTRICAL CONNECTIONS

ATypical connections

Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit. The leads of the power cord and those of the connector from the car body may be different in color.

1Connect the colored leads of the power cord in the order specified in the illustration below.

2Connect the antenna cord.

3Finally connect the wiring harness to the unit.

Antenna connector

iPod jack (see diagram )

Loop (see diagram )

Rear ground terminal

15 A fuse

Black

To metallic body or chassis of the car

Ignition switch

Line out (see diagram		)
		Yellow *2		To a live terminal in the fuse block connecting to the car battery
				(bypassing the ignition switch) (constant 12 V)
		Red		To an accessory terminal in the fuse block
							Fuse block
		Blue		To the automatic antenna if any (250 mA max.)
		Blue with white stripe			To the remote lead of other equipment (200 mA max.)
		Orange with white stripe				To car light control switch
White with black stripe	White	Gray with black stripe	Gray	Green with black stripe	Green	Purple with black stripe	Purple
	Left speaker (front)		Right speaker (front)		Left speaker (rear)		Right speaker (rear)

BConnecting the external amplifier or subwoofer

You can connect amplifier to upgrade your car stereo system.

•Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.

•Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.

Set “L/O MODE” to
“REAR” (See page 14 of the
INSTRUCTIONS.)	JVC Amplifier
Rear speakers
Set “L/O MODE” to
“WOOFER” (See page 14
of the INSTRUCTIONS.)	or
	JVC Amplifier
Subwoofer

Y-connector (not supplied for this unit)

Remote lead (blue with white stripe)

To the remote lead of other equipment or automatic antenna if any

Front speakers

CConnecting an Apple iPod

You can connect an iPod to this unit using the supplied connection cable for iPod.

Fasten the connection cable for iPod tightly across the loop using the supplied cable tie to hold the connection cable in place.

iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.

Apple iPod (separately purchased)

Connection cable for iPod (supplied)

Cable tie

Loop

*1	Not supplied for this unit.	*3	Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint
*2	Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power	*4	(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
	cannot be turned on.		Remote lead
		*5	Signal cord (not supplied for this unit).

2