JVC GNT0065-025A Precautions, Getting Started, Supplied Accessories, Prepare the Remote Control

Models: GNT0065-025A

1 24
Download 24 pages 17.71 Kb
Page 5
Image 5
Precautions

Precautions

Notes on the power cord

When you are away on travel or otherwise for an extended period of time, remove the plug from the wall outlet. A small amount of power (2.5 W) is always consumed while the power cord is connected to the wall outlet.

When unplugging the System from the wall outlet, always pull the plug, not the power cord.

Do not handle the power cord with wet hands.

Disconnect the power cord before cleaning the System or moving the System.

Do not alter, twist or pull the power cord, or put anything heavy on it, which may cause fire, electric shock, or other accidents.

If the cord is damaged, consult a dealer and have the power cord replaced with a new one.

Avoid moisture, water, dust, and high temperatures

Do not place the System in moist or dusty places.

If water gets inside the System, turn off the power and remove the plug from the wall outlet, then consult your dealer. Using the System in this state may cause a fire or electrical shock.

Do not expose the System to direct sunlight or place it near a heating device.

Notes on installation

Select a place which is level, dry and neither too hot nor too cold between 5˚C and 35˚C.

Do not install the System in a place subject to vibrations.

Do not put heavy objects on the System.

To prevent malfunction or damage of the System

Do not insert any metallic objects, such as wires, hairpins, coins, etc. into the System.

Do not block the vents.

To clean the cabinet

Use a soft cloth. Follow the relevant instructions on the use of chemically-coated cloths.

Do not use benzene, thinner or other organic solvents and disinfectants. These may cause deformation or discoloring.

There are no user-serviceable parts inside. If anything goes wrong, unplug the power cord and consult your dealer.

Getting Started

Supplied Accessories

After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied.

Remote control (x 1)

Lithium coin battery CR2025 (x 1) (The battery has been installed when shipped from the factory.)

AM loop antenna (x 1)

Prepare the Remote Control

When you use the remote control for the first time, pull out the insulation sheet.

Insulation sheet

Replacing the Battery in the Remote Control

Insert the battery into the remote control by matching the polarity (+ and –) correctly.

Notes on the power cord Lithium coin battery (product number: CR2025)

FM antenna (x 1)

DAB antenna (x 1)

If anything is missing, consult your dealer immediately.

NOTES

Store the battery in a place where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately.

Do not recharge, short, disassemble or heat the battery or dispose of it in a fire. Doing any of these things may cause the battery to give off heat, crack, or start a fire.

Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat, crack, or start a fire.

When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to give off heat, crack, or start a fire.

Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat, crack, or start a fire.

Dispose of battery in the proper manner, according to federal, state, and local regulations.

CAUTION:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

2

Page 5
Image 5
JVC GNT0065-025A Precautions, Getting Started, Supplied Accessories, Prepare the Remote Control, Notes on the power cord

FAQ

How should I handle the power cord?

Always pull the plug, not the power cord when unplugging. Do not handle the power cord with wet hands and disconnect it before cleaning or moving the system.

What should I do if the power cord is damaged?

Consult a dealer and have the power cord replaced with a new one to avoid any accidents.

What are the precautions for installing the system?

Select a level, dry place between 5C and 35C. Avoid moist or dusty places and do not install in a location subject to vibrations.