JVC GR-AXM1U Other, Symptom, Possible Causes, The tape won’t eject, shooting a very bright object

43

SYMPTOM	POSSIBLE CAUSE(S)
OTHER
The tape won’t eject.	● The battery pack is running low.
	● If the LCD monitor is not open over 60 degrees, EJECT
	switch does not function.
Some functions are not available.	● The PROGRAM AE dial is set to LOCK (☞ pg. 19).
Vertical white lines appear when	● This sometimes occurs when the contrast between the
shooting a very bright object.	background and the object is great. It is not a defect of
	the camcorder.

Bright, crystal-shaped spots appear in the LCD monitor and the viewfinder.

●Sunlight is directly entering the lens.

The rear of the LCD monitor is hot.

●The light used to illuminate the LCD monitor causes it to be hot. Close the LCD monitor to turn it off or set the power switch to OFF, and let the unit cool down.

Colored bright spots appear all over the LCD monitor.

●The LCD monitor is made with high-precision technology. However, black spots or bright spots of light (red, green or blue) may appear constantly on the LCD monitor. These spots are not recorded on the tape. This is not due to any defect of the unit. (Effective dots: more than 99.99 %.)

The indicators and the picture color	● This may occur when the surface or the edge of the LCD
on the LCD monitor are not clear.	monitor is pressed.
The LCD monitor, the viewfinder	● Wipe them gently with soft cloth. Gently wipe the LCD
and the lens have become dirty (ex.	monitor in a semicircle because wiping strongly spreads
fingerprints).	the stain and it won’t come out easily.
The picture is blurred in the Quick	● This is normal while recording in the EP mode. Some noise
Review or Retake mode.	may be present while recording in the SP mode (☞ pg. 11).
An error number (E01, etc.) appears	● Consult your nearest JVC dealer.
in the LCD monitor or viewfinder.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Power Adapter/Battery Charger, etc.) and clock battery; and then re-connect it and proceed as usual from the beginning.