
EDITING EN 45

Audio Dubbing
The audio track can be customised only when recorded in the
( pg. 33)
●Use the provided remote control.
Speaker
| START/ |
|
| STOP |
|
| PAUSE | Stereo Microphone |
REW | PLAY | |
INSERT | STOP |
|
| A.DUB |
|
1 Play back the tape to locate the point where editing will start, then press PAUSE (9).
2 While holding A. DUB (D) on the remote control, press PAUSE (9). The “9D” indicator appears.
3 Press PLAY (U), then begin “narrating”. Speak into the microphone.
●To pause dubbing, press PAUSE (9).
4 To end Audio Dubbing, press PAUSE (9), then STOP (8).
To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX”. ( pg. 32, 35)
NOTES:
●Sound is not heard from the speaker during Audio Dubbing.
●When editing onto a tape that was recorded at
●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.
●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.
●If you change from
●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in

Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.
●Use the provided remote control.
NOTES:
●Before performing the following steps, make sure that “TIME CODE” in both Recording and Playback Menus is set to “ON”.
( pg. 32, 34, 35)
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
1 Play back the tape, locate the
2 Press REW (3) until the
3 Press and hold INSERT (I) on the remote control, then press PAUSE (9). The “9I” indicator and the Time Code (min.:sec.) appear and the camcorder enters
4 Press START/STOP to begin editing.
●Confirm the insert at the time code you checked in step 1.
●To pause editing, press START/STOP. Press it again to resume editing.
5 To end Insert Editing, press START/STOP, then STOP (8).
NOTES:
●Program AE, Effects and Shutter Effects
( pg. 40) can be used to spice up the scenes being edited during Insert Editing.
●During Insert Editing, the date and time information changes.
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops. ( pg. 49)
ADVANCED FEATURES