44 EN Connections/Editing
Audio Dubbing

 

Insert Editing

The audio track can be customized only when recorded in the 12-BIT and SP modes (Z 31).

• Use the provided remote control.

START/ Microphone

STOP

PAUSE

REW PLAY

INSERT STOP

A.DUB

1Play back the tape to locate the point

where editing will start, then press PAUSE (8).

2While holding A. DUB (D) on the remote control, press PAUSE (8). The “8D” indicator appears.

3Press PLAY (3), then begin “narrating”.

Speak into the microphone.

• To pause dubbing, press PAUSE (8).

4To end Audio Dubbing, press PAUSE (8), then STOP (7).

To hear the dubbed sound during playback Set “NARRATION” to “ON” or “MIX”

(Z 29, 34).

Notes:

•Sound is not heard from the speaker during Audio Dubbing.

•When editing onto a tape that was recorded at 12-BIT, the old and new soundtracks are recorded separately.

•If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

•If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and out points. The original audio remains unchanged.

• Use the provided remote control.

Notes:

•Before performing the following steps, make sure that “TIME CODE” in both Recording and Playback Menus is set to “ON”. (Z 29, 34).

•Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

1Play back the tape, locate the Edit-Out point and press PAUSE (8). Confirm the time code at this point (Z 20).

2Press REW (1) until the Edit-In point is located, then press PAUSE (8).

3Press and hold INSERT (I) on the remote control, then press PAUSE (8). The “8I” indicator and the Time Code (min.:sec.) appear and the camcorder enters Insert- Pause mode.

4Press START/STOP to begin editing.

•Confirm the insert at the time code you checked in step 1.

•To pause editing, press START/STOP. Press it again to resume editing.

5To end Insert Editing, press START/STOP, then STOP (7) on the remote control.

Notes:

•Program AE, Effects and Shutter Effects

(Z 39) can be used to spice up the scenes being edited during Insert Editing.

•During Insert Editing, the date and time information changes.

•If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

•During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops.