|
|
|
|
| GETTING STARTED | EN 13 | |
How To Attach The Core Filter |
|
|
|
|
| ||
|
|
|
| Power | |||
|
| ||||||
Attach the core filters to the cables. The core |
|
|
|
|
|
|
|
| This camcorder’s | ||||||
filter reduces interference. |
| ||||||
| lets you choose the most appropriate source of | ||||||
1 Release the stoppers on both ends of the |
| ||||||
| power. Do not use provided power supply units | ||||||
core filter. |
| with other equipment. | |||||
Charging The Battery Pack
Stopper
2 Run the cable through the core filter, leaving approx. 3 cm of cable between the cable plug
BATT. RELEASE
Battery pack
Open the cover.
and the core filter.
Wind the cable once around the outside of the core filter as shown in the illustration.
Core filter
3 cm
Wind once.
3 Close the core filter until it clicks shut.
| To |
| DC connector |
Arrow |
|
Battery pack mount | mark |
Power switch 
POWER/CHARGE 
lamp
AC Adapter
To AC outlet
NOTES:
●Take care not to damage the cable.
●When connecting a cable, attach the end with the core filter to the camcorder.
1 Set the Power Switch to “OFF”.
2 With the arrow on the battery pack pointing right, push the battery pack slightly against the battery pack mount a.
3 Slide the battery pack to the right until it locks in place b.
4
5 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.
6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
CONTINUED ON NEXT PAGE