JVC GR-DVM5 manual Power, Charging The Battery Pack, Using The Battery Pack

Connect the AC Adapter to the camcorder.

			GETTING STARTED		EN 13
	Power	To detach the battery pack
		Slide the battery pack upward while pressing
This camcorder’s 2-way power supply system		PUSH BATT. to detach it.
lets you choose the most appropriate source of		Battery pack		Charging time
power. Do not use provided power supply units
		BN-VF707U*		Approx. 1 hr. 30 min.
with other equipment.
Charging The Battery Pack		BN-VF714U		Approx. 2 hr. 40 min.
		BN-VF733U		Approx. 5 hr. 40 min.

Power switch

M A

POWER/CHARGE lamp

POWER/

CHARGE

Battery pack mount

PUSH BATT.

Battery pack

Arrow

mark To DC connector

Open the cover.

To AC outlet

AC Adapter (ex. AP-V17E)

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing downward, push the battery pack slightly against the battery pack mount a.

3 Slide down the battery pack until it locks in place b.

4

5 Connect the Power Cord to the AC Adapter. (AP-V14E only)

6 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

* Provided

NOTES:

●This product includes patented and other proprietary technology and will operate only with JVC Data Battery. Use the JVC BN-VF707U/VF714U/VF733U battery packs. Using generic non-JVC batteries can cause damage to the internal charging circuitry.

●If the protective cap is attached to the battery pack, remove it first.

●During charging, the camcorder cannot be operated.

●Charging is not possible if the wrong type of battery is used.

●When charging the battery pack for the first time or after a long storage period, the POWER/ CHARGE lamp may not light. In this case, remove the battery pack from the camcorder, then try charging again.

●If the battery operation time remains extremely short even after having been fully charged, the battery is worn out and needs to be replaced.

Please purchase a new one.

●Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

●Using the optional AA-VF7 Battery Charger, you can charge the BN-VF707U/VF714U/VF733U battery pack without the camcorder.

●After 5 minutes has elapsed in Record-Standby mode with the cassette inserted, the camcorder will automatically turn off its power supplied from the AC adapter. In this case, the battery charge starts if the battery is attached to the camcorder.

Using The Battery Pack

Perform steps 2 – 3 in “Charging The Battery Pack”.

Maximum continuous recording time

Battery pack	LCD monitor	Viewfinder on
	on
BN-VF707U*	1 hr. 5 min.	1 hr. 25 min.
BN-VF714U	2 hr. 20 min.	3 hr.
BN-VF733U	5 hr. 25 min.	7 hr. 5 min.
* Provided

CONTINUED ON NEXT PAGE

GETTING STARTED