JVC GR-DVM76 instruction manual Power  pg, Environment is too cold, charging may be incomplete

Models: GR-DVM76

1 104
Download 104 pages 34.83 Kb
Page 81
Image 81

DETAILS

EN 81

 

 

ITEMS

NOTES

V Power ( pg. 10)

Perform charging where the temperature is between 10°C and 35°C (50°F and

 

95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for charging. If

 

the environment is too cold, charging may be incomplete.

 

Charging times noted above are for a fully discharged battery pack.

 

Charging time varies according to the ambient temperature and the status of the

 

battery pack.

 

To avoid interference with reception, do not use the AC Adapter near a radio.

 

Since the AC Adapter processes electricity internally, it becomes warm during

 

use. Be sure to use it only in well-ventilated areas.

 

The following operation stops charging:

 

•Set the Power Switch to “P”, “A” or “M”.

 

•Disconnect the AC Adapter from the camcorder.

 

•Unplug the AC Adapter from the AC outlet.

 

•Detach the battery from the camcorder.

 

 

V VIDEO

When you use the LCD monitor outdoors in direct sunlight, the LCD monitor

RECORDING

may be difficult to see. If this happens, use the viewfinder instead.

( pg. 19, 20)

The cassette holder cannot be opened unless a power supply is attached.

 

There may be a delay after you open the cassette holder cover until the cassette

 

holder opens. Do not use force.

 

Once the cassette holder is closed, it recedes automatically. Wait until it recedes

 

completely before closing the cassette holder cover.

 

When the Recording Start/Stop button is pressed, it may take a few seconds

 

before actual recording starts. The “T” indicator starts rotating when the

 

camcorder actually starts recording.

 

The time required to calculate and display the remaining tape length, and the

 

accuracy of the calculation, may vary according to the type of tape used.

 

“TAPE END” appears when the tape reaches its end, and the power goes off

 

automatically if left in this condition for 5 minutes. “TAPE END” also appears

 

when a cassette at its end is loaded.

 

During recording, sound is not heard from the speaker. To hear the sound,

 

connect optional headphones to the headphone connector. (GR-DVM96 only)

 

The sound volume is at the level it was adjusted to during playback. ( pg. 22)

 

 

Page 81
Image 81
JVC GR-DVM76 Power  pg, Environment is too cold, charging may be incomplete, Following operation stops charging