JVC GR-FXM15 specifications 48ENUSINGTHEREMOTECONTROLUNITcont, Insert Editing, Find Edit-Out Point

48ENUSINGTHEREMOTECONTROLUNIT(cont.)

Power Switch

REW (2) Button

FF (3) Button PLAY/PAUSE (4/6) Button

	STOP (5) Button
	COUNTER R/M Button
Display
w	Insert editing
	indicator
M 0 : 12 : 34	Tape Counter

Remote sensor

START/STOP	PAUSE
REW	STOP
PLAY	INSERT
	RM-V700U
	(optional)

Insert Editing

You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the RM-V700U remote control unit to perform this procedure.

1 SELECT OPERATION MODE Set the Power Switch to “PLAY”.

2 FIND EDIT-OUT POINT

Play back the tape, locate the Edit-Out point and press PAUSE on the camcorder or the remote control.

3 RESET COUNTER

Press and hold COUNTER R/M for more than

1 second to reset the tape counter, then press again for less than 1 second so that “M” appears.

4 FIND EDIT-IN POINT

Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the Edit-In point where the new scene should start.

5 ENGAGE INSERT EDITING MODE Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.

6 BEGIN INSERT EDITING

Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

7 END INSERT EDITING

Press STOP.

NOTES:

●During Insert Editing, the original audio will be heard from the speaker.

●After step 5, Retake (☞ pg. 19) can be performed.

●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

●Only the video signal is recorded in the Insert Editing mode.