Basic and Common Operations
Setting the Clock
Before operating the unit any further, first set the unit’s clock.
To show the clock when the unit is turned on
On the remote control ONLY:
When you plug in the power cord, “AM 12:00” starts flashing
Press DISPLAY.
DISPLAY
on the display.
You can set the clock when the unit is either turned on or in standby mode.
The clock indication appears on the display.
To return to the normal display, press DISPLAY
again.
On the remote control ONLY:
1 Press CLOCK/TIMER.
The hour digits start flashing on the display.
2 Press 
UP or 
DOWN to adjust the hour, then press CLOCK/ TIMER.
The minute digits start flashing.
•When you press and hold 
UP or 
DOWN, the hour digit changes continuously.
CLOCK/
TIMER
UP
DOWN
CLOCK/
TIMER
When playing an MP3 disc
Pressing DISPLAY shows the elapsed playing time instead of the clock time.
To change the clock
1 | Make sure the (timer) indicator and the timer mode |
| indicator (DAILY) are not lit on the display. |
| • If they are lit, press and hold CLOCK/TIMER until they |
| go off. |
2 | Press CLOCK/TIMER repeatedly until the unit enters |
| the clock setting mode (the hour digits start flashing |
| on the display). |
| First time you press CLOCK/TIMER, the unit enters the |
| timer setting mode. (See page 20.) |
3 | Repeat steps 2 and 3 of the procedure “Setting the |
| Clock.” |
3 Press 
UP or 
DOWN to adjust the minute, then press CLOCK/TIMER.
The
4 Press and hold CLOCK/TIMER again so that the |
(timer) indicator and the timer mode indicator |
(DAILY) go off. |
To turn off the clock indication (power save mode)
•When you unplug the power cord or if a power failure occurs The clock is reset to “AM 12:00” right away. If this happens, set the clock again.
•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.
On the remote control ONLY:
Press DISPLAY while the unit is in standby mode. DISPLAY “DISPLAY OFF” appears on the display and the
clock indication goes off.
To turn on the clock indication, press DISPLAY again while the unit is in standby mode. “DISPLAY ON” appears on the display.
9
