JVC GVT0134-001B, CA-FSS57 Getting Started continued, Connecting Speakers, terminal, AM antenna

Models: CA-FSS57 GVT0134-001B

1 58
Download 58 pages 31.87 Kb
Page 10
Image 10
Getting Started (continued)

Getting Started (continued)

AM antenna

1

ANTENNA

Vinyl-covered wire

(not supplied)

2

AM loop antenna

(supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

Make sure the antenna conductors do not touch any other terminals or connecting cords.

Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

To connect speakers

You can connect the speakers using the speaker cords.

1

 

2

3,4

SPEAKERS

RIGHT

LEFT

Speaker

Speaker

cord

cord

Right speaker

Left speaker

1If the cords are covered with insulation, remove a short section of insulation at the end of each cord by twisting and pulling it off.

2Hold the clamp of the speaker terminal.

3Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: red cord to

ªand black cord to ·.

4Release your finger from the clamp.

IMPORTANT:

Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

DO NOT connect more than one speaker to one speaker terminal.

7

Page 10
Image 10
JVC GVT0134-001B manual Getting Started continued, Connecting Speakers, 2Hold the clamp of the speaker terminal, AM antenna