AMX MAX-CSD 10 manual MAX-CSEand MAX-CSD10Installation, MAX-CSEand MAX-CSD10Connections and Wiring

MAX-CSE and MAX-CSD10 Installation

MAX-CSE and MAX-CSD10 Installation

MAX-CSE and MAX-CSD10 Connections and Wiring

The MAX CSE and MAX-CSD10 are configured to be used as standalone units running on a network capable of supporting the up to a 6Mbps data rate. It is recommended that you set up the unit locally prior to installing it within an AC-RK 19-inch rack unit, as described on page 17.

Port Assignments and Functionality

The rear Port Assignments are as follows:

MAX-CSE Port Assignments

Description	ICSP Port #
Video Encoder	1
RS-232/422/485 (DB9) Serial Port	2
IR/Serial Port	3
I/O Port	4
IR RX Port	5
LCD Display	6

MAX-CSD10 Port Assignments

Description	ICSP Port #
Video Decoder	1
RS-232/422/485 (DB9) Serial Port	2
IR/Serial Port	3
I/O Port	4
IR RX Port	5
LCD Display	6

Wiring Guidelines - Direct Power

The MAX-CSE and MAX-CSD10 units require the use of either an external 12 VDC-compliant power supply or an 802.3af-compliant device to provide DC power. Power can be fed to the unit through either the rear 2-pin 3.5mm mini-Phoenix PWR connector or the rear Ethernet connector (PoE).

Use the power requirements from the Specifications table on page 2 to determine the unit’s power draw.

This unit should only have one source of incoming power. Although the unit can be connected to two separate power sources, the

12 VDC-compliant power input overrides the PoE. Refer to the Wiring Guidelines - Indirect Power (via PoE) section on page 10 for specific PoE wiring procedures and restrictions.

MAX-CSE/MAX-CSD10 Operation/Reference Guide 9