| |
| |
| |
|
|
Supported Audio Codecs: | • MPEG Audio Level 2 (MP2) |
| • MPEG Audio Level 3 (MP3) |
|
|
Front Panel Components: |
|
• ID pushbutton: | Used to set the NetLinx ID (Device only) assignment and reset the unit to |
| factory defaults. Press and hold this button for at least 10 seconds to set |
| the unit back to its default settings. |
• Status LED: |
|
Green LED provides an indication of both the system status and communi- | |
| cation status with the target Master. |
| 1 blink every 5 seconds indicates there is currently active communication |
| between the CSE and a target Master. |
• LCD Display: |
|
Provides system information such as the currently used IP Address. | |
• IR Receiver: |
|
Receives 38KHz AMX IR codes. | |
|
|
Rear Panel Connectors: |
|
• COMPOSITE IN: | BNC connector (female) supports Composite Video Input (NTSC/PAL). |
• 12VDC PWR: |
|
| an optional 12 |
• |
|
•ETHERNET 10/100:RJ-45 port provides 10/100 Mbps network communication and POE. LEDs show communication activity, connection status, speeds, and mode infor- mation:
•SPD (speed) - Yellow LED lights On when the connection speed is 100 Mbps and turns Off when the speed is 10 Mbps.
•L/A (link/activity) - Green LED lights On when the Ethernet cables are connected/terminated correctly, and then blinks when receiving Ethernet data packets.
| This port automatically negotiates the connection speed (10 Mbps or 100 |
| Mbps), and whether to use half or full duplex mode. |
• AUDIO R/L: |
|
• Two RCA connectors support | |
| signals. |
• |
|
| 300, 600, 1,200, 2,400, 4,800, 9,600, 19,200, 38,400, and 115,200 Baud |
| rates |
| • 8 or 9 Data bits |
| • 1 or 2 Stop bits |
| • Even, Odd, Mark, Space, and None parity settings |
| • CTS and RTS handshaking |
| • XON/XOFF handshaking |
• MIC: |
|
1/8” | |
• IR/Serial: |
|
| IR/Serial control output by generating IR with the use of an IR Emitter |
| (while in IR mode). |
| This port supports |
| also generate IR with no carrier frequency. |
3 | |
|
|