PoE - Special wiring instructions
Before beginning the connection from the PoE switch to the target MAX unit, follow these instructions carefully:
When using PoE, you must FIRST ground the unit to provide ESD protection.
Refer to the procedures outlined within the previous Preparing captive wires section on page 10.
Install a single wire into the
Connect this wire to a grounded source (FIG. 4). This GND wire provides the necessary ESD protection to the unit. Only after this step has been completed can you continue on to the wiring of the PoE connection.
The length of the GND wire should not exceed 6 feet (1.83 meters).
|
| R |
|
|
| E |
|
|
| A |
|
|
| R |
|
CSE |
| Ethernet |
|
|
| PWR | PWR + |
|
| GND - | |
|
|
|
FIG. 4 ESD grounding and PoE connection of a MAX unit
PoE switch
Grounded Metal
plate or object
Connect a CAT5/CAT6 Ethernet cable from the
11 | |
|
|