AMX MAX-CSE, MAX-CSD 10 Wiring the MAX-CSD10connectors and cables, I/O Port Wiring Specifications

MAX-CSE and MAX-CSD10 Installation

When used for outputs, the I/O port acts as a switch to GND and is rated at 200 mA @ 12 VDC. This device can utilize up to 2 I/O ports (see table below).

The PWR pin provides +12 VDC @ 200 mA and is designed as a power output for the PCS2 or VSS2 (or equivalent).

The GND connector is a common ground and is shared by all I/O ports. A common ground is shared with I/O ports 1 & 2 (see table below)

I/O Port Wiring Specifications

Pin Signal Function

1	GND	Signal GND
2	I/O 1	Input/Output
3	I/O 2	Input/Output
4	12 VDC	PWR

Wiring the MAX-CSD10 connectors and cables

The rear connectors on the MAX-CSD10 are used to take an incoming media stream and then output it as an RGB video signal (with audio). FIG. 11 shows a sample wiring configuration where a MAX- CSD10 receives a video stream from a remote MAX-CSE and then distributing the content to its connected media device.

S-Video or COMP Video In
	(DVD, VCR, etc.)
Outbound Audio/Video/Data
via Ethernet		Video)-(S			(BNC)
		Audio In	or			Power
		(Stereo RCA)
						supply
						Direct PWR
		MAX-CSE				Connection
		Video Encoder
		Audio In
		(Stereo RCA)
	Right Channel	- Left Channel		RGB Video Out
	Red -	White		(to target device)
Inbound			or
Audio/Video/Data		Video)-(S		(BNC)
via Ethernet (RJ-45)						Power
						supply
						Direct PWR
	MAX-CSD10					Connection
	Video Decoder

The BNC connector can be adapted to use an RCA plug by using the

INCLUDED BNC to RCA Adapter.

FIG. 11 Sample wiring configuration using a CSD10 and a target device

16 MAX-CSE/MAX-CSD10 Operation/Reference Guide