AMX MAX-CSD 10 manual Displaying Stream Content, MAX-CSE/MAX-CSD10Operation/Reference Guide

Displaying Stream Content

that the unit is detecting an incoming signal (shown by the word SYNC appearing in the Video Sync section of the UI).

The most common error found is when a bad cable is not detected and therefore no signal is available for the unit to encode. The encoding process can continue on a MAX-CSE even without an actual signal being detected.

9.To complete the setup when using an RTP Transport Protocol on the MAX-CSE, repeat steps 5 and 6 to open another instance of the same application.

10.Within the Port field of the Network tab (in the second player window - B in FIG. 49), enter the value used with in the Target Audio Port field in the MAX’s Encoder Profiles page. This value can not match the value used for the previously entered Target Port.

RTP Video Stream Component RTP Audio Stream Component

AB

FIG. 49 VLC Player Adjustments (using a sample RTP stream to display each component separately)

MAX-CSE/MAX-CSD10 Operation/Reference Guide 73