Power over Ethernet (PoE) wiring
PoE can be used to indirectly provide DC power to this
PoE power is overridden if a direct power feed (via the rear
Any
Ethernet LEDs
SPD - Speed LED lights (yellow) when |
|
the connection speed is 100 Mbps |
|
and turns Off when the speed |
|
| |
is 10 Mbps. | SPD |
| L/A |
L/A - Link/Activity LED lights |
|
| |
(green) when the Ethernet |
|
cables are connected and |
|
| |
terminated correctly. |
|
FIG. 7 Ethernet LEDs
DB9 Device Port: Connections and Wiring
ETHERNET 10/100
FIG. 8 shows the connector pinouts for the rear
DB9 Device Port pinouts (male connector)
5 | 9 |
|
|
| |
8 |
|
|
| ||
4 |
|
|
| ||
| Pin 2: RX signal | Pin 1: RX - | Pin 1: A (strap to 9) | ||
3 |
| ||||
| Pin 3: TX signal | Pin 4: TX + | Pin 4: B (strap to 6) | ||
2 |
| ||||
7 | Pin 5: GND | Pin 5: GND | Pin 5: GND | ||
1 | |||||
| 6 | Pin 7: RTS | Pin 6: RX + | Pin 6: B (strap to 4) | |
|
| Pin 8: CTS | Pin 9: TX - | Pin 9: A (strap to 1) | |
| Male |
|
|
| |
FIG. 8 |
14 |