AMX MAX-CSD 10 manual IR/Serial Send Commands Cont, PORT 3 IR,CARRIER,IO LINK, NetLinx Programming

	NetLinx Programming
IR/Serial Send_Commands (Cont.)
Command	Description
CP	You can set the Pulse and Wait times with the 'CTON' and 'CTOF' commands.
Halt and Clear all active or	Syntax:
buffered IR commands, and	SEND_COMMAND <DEV>,"'CP',<code>"
then send a single IR pulse.
	Variable:
	code = IR port's channel value 0 - 252 (253 - 255 reserved).
	Example:
	SEND_COMMAND IR_1,"'CP',2"
	Clears the active/buffered commands and pulses IR_1 port's channel 2.
CTOF	Off time settings are stored in non-volatile memory. This command sets the
Set the duration of the Off	delay time between pulses generated by the 'CH' or 'XCH' send commands in
	tenths of seconds.
time (no signal) between IR
	Syntax:
pulses for channel and IR
function transmissions.	SEND_COMMAND <DEV>,"'CTOF',<time>"
	Variable:
	time = 0 - 255. Given in 1/10ths of a second. Default is 5 (0.5 seconds).
	Example:
	SEND_COMMAND IR_1,"'CTOF',10"
	Sets the off time between each IR pulse to 1 second.
CTON	This command sets the pulse length for each pulse generated by the 'CH' or
Set the total time of IR pulses	'XCH' send commands in tenths of seconds.
transmitted and is stored in	Syntax:
non-volatile memory.	SEND_COMMAND <DEV>,"'CTON',<time>"
	Variable:
	time = 0 - 255. Given in 1/10ths of a second. Default is 5 (0.5 seconds).
	Example:
	SEND_COMMAND IR_1,"'CTON',20"
	Sets the IR pulse duration to 2 seconds.
GET BAUD	The port sends the parameters to the device that requested the information.
Get the IR port’s current	Only valid if the port is in Data Mode (see SET MODE command).
DATA mode communication	The port responds with:
parameters.	<port #> <baud>,<parity>,<data bits>,<stop bits>
	Syntax:
	SEND_COMMAND <DEV>,"'GET BAUD'"
	Example:
	SEND_COMMAND IR_1,"'GET BAUD'"
	System response example:
	PORT 3 IR,CARRIER,IO LINK 0
GET MODE	The port responds with: <port #> <mode>,<carrier>,<io link channel>.
Poll the IR/Serial port's	Syntax:
configuration parameters and	SEND_COMMAND <DEV>,"'GET MODE'"
report the active mode
	Example:
settings to the device
requesting the information.	SEND_COMMAND IR_1,"'GET MODE"
	The system could respond with:
	PORT 3 IR,CARRIER,IO LINK 0

MAX-CSE/MAX-CSD10 Operation/Reference Guide 95