AMX MAX-CSD 10 manual Displaying Stream Content, MAX-CSE/MAX-CSD10Operation/Reference Guide

Displaying Stream Content

FIG. 42 Stream Profiles page

8.From the Profile field, click on the drop-down arrow and from the available list, choose the desired encoder setting which conforms to the available data throughput on your network. Although the default selection is Home Theater (Max), the user can choose from up to 6 pre-created entries and one Custom entry which makes every field user-definable.

For the purpose of these procedures, we’ve been informed that our network can handle the full 6 Mbps data throughput, so we’ll select Home Theater (Max).

9.Click the Apply button to save the encoding profiles to the MAX.

10.From the Stream section of the page, locate the Transport Protocol field and use the drop-down arrow to select a desired protocol. For the purposes of these procedures, select UDP as the protocol.

An UDP protocol is typically used with higher-bandwidth streams and only requires the entry of a single Target Port because both the video and audio are combined into a single media stream. With this method, the Modero panel always utilizes an audio port value of two greater than that used by the Target Port.

An RTP protocol is typically used both with lower-bandwidth streams and when user wants to purposely separate the video and audio information into two distinct streams. With this method, the Target Audio Port must be manually entered and cannot be the same value as the Target Port used for video.

11.Enter the previously obtained IP Address of the target Modero panel (FIG. 41) into the Target Address field.

66 MAX-CSE/MAX-CSD10 Operation/Reference Guide