| NetLinx Programming | |
| ||
|
| |
Command | Description | |
|
| |
START RTSP SERVER | If the RTSP SERVER started properly the 'GET SESSION LIST' table will | |
Attempts to START the RTSP | return with a 1. Otherwise it will return 0. This command is not accessible if | |
SERVER and will retrieve | system mode is not set to RTSP | |
Syntax: | ||
and update the session list | ||
info. | SEND_COMMAND <DEV>, 'START RTSP SERVER <num>' | |
| ||
| Variables: | |
| num = 1 to 10: One of the ten RTSP SERVER Entries. | |
| Example: | |
| SEND_COMMAND <DEV>, 'START RTSP SERVER 2' | |
|
| |
STOP | Stops reception of audio and video. | |
Stops transmission of audio | Syntax: | |
and video. | SEND_COMMAND <DEV>,'STOP' | |
| ||
| Example: | |
| SEND_COMMAND DECODER, 'STOP' | |
|
|
RS-232/422/485 Send_Commands (Port 2)
The serial port is located at Port 2 in NetLinx D:P:S nomenclature. The serial port supports the following commands and escape sequences. In these examples: <DEV> = device.
RS-232/422/485 Send_Commands
Command | Description | |
|
| |
B9MOFF | Disables | |
Set the port's communication | settings on the serial/data port to the last programmed parameters. This | |
parameters for stop and data | command works in conjunction with the 'B9MON' command. | |
Syntax: | ||
bits according to the software | ||
settings on the | SEND_COMMAND <DEV>,"'B9MOFF'" | |
(default). | ||
Example: | ||
| ||
| SEND_COMMAND RS232_1,"'B9MOFF'" | |
| Sets the | |
|
| |
B9MON | Enables | |
Override and set the current | the 'B9MOFF' command. | |
Syntax: | ||
communication settings and | ||
parameters on the | SEND_COMMAND <DEV>,"'B9MON'" | |
port to 9 data bits with one | ||
Example: | ||
stop bit. | ||
| ||
| SEND_COMMAND RS232_1,"'B9MON'" | |
| Resets the | |
| stop bit, and | |
|
| |
CHARD | Syntax: | |
Set the delay time between | SEND_COMMAND | |
all transmitted characters to | Variable: | |
the value specified (in 100 | ||
time = 0 - 255. Measured in 100 microsecond increments. | ||
Microsecond increments). | ||
Example: | ||
| ||
| SEND_COMMAND | |
| Sets a | |
|
|
89 | |
|
|