AMX MAX-CSE, MAX-CSD 10 manual A/V Set up Page Features

MAX-CSE Web Interface

A/V Set up Page

The A/V Set up page (FIG. 17) is accessed by clicking on the Audio/Video button in the Navigation Bar. This page allows a user (with the proper access rights) to configure the properties associated with both the incoming video and audio content.

FIG. 17 A/V Set up page

The following table lists the A/V Setup page features that can be configured by an administrator or other authorized user.

A/V Set up Page Features

Feature	Description
Video:	This section allows the user/administrator to define the detection and format parameters for
	the incoming video signal.
• Video In
	These two radio boxes provide the option to select from either Composite or S-Videoas the
	incoming video source type. The selected type determines which rear connector is used as
	the video input connector.
	This selection instructs the MAX-CSE to use/expect video from a specified rear video con-
	nector. As an example: setting the Video In option to Composite, tells the MAX-CSE to begin
	detecting a video signal from the rear Composite connector.
• Video Port
	These two radio boxes provide the option to select from either NTSC or PAL as the format
	type of the incoming video signal.
	This selection instructs the MAX-CSE to use/expect a particular video format.
Audio:	This section allows the user/administrator to define the gain used by the current microphone
	input.
• Mic Gain
	This field allows the user to enter a value (from 0-99) associated with the gain used by the
	rear microphone input.
	The incoming microphone audio signal can be muted either by toggling the state of the
	Microphone icon located at the top of each UI page or entering a value of zero into this field.

32 MAX-CSE/MAX-CSD10 Operation/Reference Guide