AMX MAX-CSD 10, MAX-CSE manual Changing the Encoder Profile, Set the SAP Settings

MAX-CSE Web Interface

If a stream is currently in effect while these parameters are altered, clicking the Apply button will cause the outgoing stream to stop and then incorporate the new settings without restarting.

Encoder Profiles and Parameters

Profiles:	Stream Quality:	Video Defaults:	Audio Defaults:	Protocol
Home Theater	Maximum	• Codec: MPEG-2	• Codec: MP2	• UDP
		• Video In Rate: 6Mbps	• Sampling Rate: 48 KHz
		• Resolution: D1	• Effective Rate: 192 Kbps
		• Mode (encoding): CBR
High Quality	High	• Codec: MPEG-2	• Codec: MP2	• UDP
		• Video In Rate: 4Mbps	• Sampling Rate: 48 KHz
		• Resolution: D1	• Effective Rate: 192 Kbps
		• Mode (encoding): CBR
Good Quality	Medium	• Codec: MPEG-4	• Codec: MP2	• RTP
		• Video In Rate: 3Mbps	• Sampling Rate: 48 KHz
		• Resolution: D1	• Effective Rate: 192 Kbps
		• Mode (encoding): CBR
Standard Quality	Low	• Codec: MPEG-4	• Codec: MP2	• RTP
		• Video In Rate: 2Mbps	• Sampling Rate: 48 KHz
		• Resolution: D1	• Effective Rate: 192 Kbps
		• Mode (encoding): CBR
VCR	Lower	• Codec: MPEG-4	• Codec: MP3	• RTP
		• Video In Rate: 1Mbps	• Sampling Rate: 32 KHz
		• Resolution: SIF	• Effective Rate: 96 Kbps
		• Mode (encoding): VBR
Security Camera	Min	• Codec: MPEG-4	• Codec: MP3	• RTP
		• Video In Rate: 500 Kbps	• Sampling Rate: 32 KHz
		• Resolution: SIF	• Effective Rate: 96 Kbps
		• Mode (encoding): VBR
Custom	User Dependant	• User Selectable:	• User Selectable	• UDP/RTP
		UDP = MPEG-2 only
		RTP = MPEG-2/4

When the a lower quality Encoder Profile is used (Good Quality or lower), the Stream parameters default to using RTP as a Transport Protocol.

Changing the Encoder Profile

1.From the Stream Profiles page, select an option from the Profile drop-down menu. All but the Custom option contain preset parameters.

2.If you selected the Custom option, select the appropriate options from the Video and Audio sections.

3.If you wish to change the Stream profile, select between RTP and UDP in the Transport Protocol drop-down menu.

4.Change the Target Address, Target Port, and Target Audio Port information, if necessary.

5.Set the SAP Settings:

6.To save your changes, click the Accept button. To return to the previously saved settings, click Cancel.

MAX-CSE/MAX-CSD10 Operation/Reference Guide 31