MasterPage: Start_Right | |
M5E3PAL.book Page 9 Tuesday, June 14, 2005 1:40 PM |
|
GETTING STARTED | EN 9 |
Attaching the Core Filter | LCD Monitor |
Attach the core filters to the cables. The core filter reduces interference.
1 Release the stoppers on both ends of the core filter.
Stopper
2 Run the cable through the core filter, leaving approx. 3 cm of cable between the cable plug and the core filter.
Wind the cable once around the outside of the core filter as shown in the illustration.
Pull on the end 
of the LCD monitor and open the LCD monitor fully. It can rotate 270°.
Core Filter
3 cm
Wind once.
●Wind the cable so that it is not slack.
3 Close the core filter until it clicks shut.
NOTES:
●Take care not to damage the cable.
●When connecting a cable, attach the end with the core filter to the camera.
