JVC HR-DD840KR manual On-Screen, Timer, Programming, Access Program SET, Select Program Number

42ENTIMERRECORDING(cont.)

On-Screen				You can directly program the VCR’s timer to record up to 8
				shows, as far as a year in advance. Remember, the clock must be
				on the remote control light to tell you which button to press next.
				set before you can program the timer (☞ pg. 5 or 7).You can also
Timer				use the optional Illumi-Guide feature, where the relevant buttons
				The Illumi-Guide feature is activated by the ILLUMI GUIDE
				button on the remote control. The Illumi-Guide feature is only
				active when the remote control's TV/CABLE/VCR switch is set to
Programming				"VCR". (Illumi-Guide is an optional help feature which makes
				programming easier. It is not necessary to use Illumi-Guide to
				program the VCR.)
Turn on the TV and select the VCR channel 3 or 4 (or AV				1	LOAD A CASSETTE
					Make sure the record safety tab is intact. If not, cover
mode).
					the hole with adhesive tape, then load it into the VCR.
					● The VCR comes on, and the counter is reset,
					automatically.
	OK				ACCESS ON-SCREEN
			q		MENU
	CH			2	To use the Illumi-Guide feature press ILLUMI GUIDE.
MENU					The MENU, REW, PLAY and FF buttons will light.
					Press MENU as many times as necessary to bring up the
					Main Menu screen.
	1	2	3		● If you are using the Illumi-Guide feature, OK blinks
					when the following buttons are lit: NUMBER keys (0-9),
NUMBER	4	5	6		PUSH JOG, CANCEL and MENU.
					ACCESS PROGRAM SET
NUMBER "8" 7		8	9
			NUMBER "9"		SCREEN
		0	TIMER

CH	3	Make sure the highlight bar (arrow) is on				"PROGRAM
		SET", then press OK.
TV/CABLE/VCR		● If you are using the Illumi-Guide feature, OK blinks
FF		when the following buttons are lit: NUMBER keys (0
		– 9), PUSH JOG, CANCEL and MENU.
REW
		SELECT PROGRAM NUMBER
	4
		Press the appropriate			PROGRAM 1
		NUMBER keys or CH 5°
OK
		or PUSH JOG 5	°	to select	DATE	– –/– –
MENU					START	– –:– – AM
		a vacant program number,			STOP	– –:– – AM
		then press OK. The first time
PUSH JOG					CHANNEL	– – SP
		you set the timer program-			PRESS NUMBER KEY (O–9)
		ming function, all the
ILLUMI GUIDE		program numbers will be			OR (5,°), THEN (OK)
					PRESS (MENU) TO END
		blank; in this case just press
		OK when the Program Set screen appears.
When Using The Illumi-Guide Feature		● If you are using the Illumi-Guide feature, OK blinks
		when the following buttons are lit: NUMBER keys
● Buttons light or blink on the remote control for
		(0 – 9), PUSH JOG, CANCEL and MENU.
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.

●If for some reason the remote control's signal is not received by the VCR, press MENU as many times as necessary to return to the normal screen and extinguish all illuminated buttons, and re-perform the timer programming procedure from the beginning.