●Make sure the channel position number you wish to record is displayed; if not, see "SHOWVIEW Setup" on page 22 and set the Guide Program number for that SHOWVIEW number correctly.
●If the number you entered is invalid, "ERROR" appears on the screen and "Err" appears on the display panel. Press CANCEL to backspace and input a valid SHOWVIEW number.
●If "ERROR=GUIDE PROG" appears on the screen, see "ATTENTION – Regarding Guide Program Number Set" on this page.
SET TAPE SPEED
4 Press SP/LP ( 
) to set the tape speed.
E
N
25
ATTENTION
Regarding Guide Program Number Set
"ERROR=GUIDE PROG" appears after performing step 3 on the previous page if the Guide Program number for the SHOWVIEW number you entered has not been set.
● If the recorder is in the stop or rewind or
• Press the NUMBER keys or PUSH JOG %Þto input the channel position number your recorder receives that station on, then press OK.
GUIDE PROG SET
RETURN TO NORMAL SCREEN
5 Press OK.
●Repeat steps 1–5 for each additional programme.
GUIDE PROG | TV PROG |
2 | – – |
[5°] = |
|
[MENU] : EXIT |
|
(Ex.) To
*If your recorder receives RTR on the channel position 2, press OK after entering "2".
ENGAGE RECORDER’S TIMER MODE
6 Press TIMER. The recorder turns off automatically.
NOTE:
To Delay The Stop Time . . .
. . . press ADD TIME (NUMBER Key "5") after pressing OK in step 3. Each time you press, the Stop time is delayed by 5 minutes (meaning that 5 minutes of recording time is added). You can easily compensate for anticipated programme schedule delays this way.
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key “9”) for weekly serials or DAILY (NUMBER key “8”) for daily serials
You can programme this recorder to
• Press MENU, then try again from step 1.
●If the recorder is in a mode other than the above mentioned modes, press MENU first and input the correct Guide Program number for that SHOWVIEW number (☞ pg. 22, "SHOWVIEW Setup"), then try again from step 1.
