JVC HR-J277MS, HR-J271MS, LPT0421-001B specifications Basic, Connections

INSTALLINGYOURNEWRECORDER

EN3

Basic		It's essential that your video recorder be properly connected.
		FORMED.
		Follow these steps carefully. THESE STEPS MUST BE COM-
Connections		PLETED BEFORE ANY VIDEO OPERATION CAN BE PER-
			Make sure the package contains all of the accessories
			CHECK CONTENTS
Aerial terminal		1 listed in "Specifications" (☞ pg. 43).
		2	SITUATE RECORDER
RF Cable			Place the recorder on a stable, horizontal surface.
(provided)
			CONNECT RECORDER TO
			TV
			The connection method you use depends on the type
Back of TV	TV Aerial		of TV you have.
AV-IN terminals		3 RF CONNECTION
	Cable
AV Cable			● To Connect To A TV With NO AV Input Terminals . . .
(not provided)			a– Disconnect the TV aerial cable from the TV.
			b– Connect the TV aerial cable to the ANT. IN jack
			on the rear panel of the recorder.
			c– Connect the provided RF cable between the RF
			OUT jack on the rear panel of the recorder and
			the TV's aerial terminal.

Mains Power			AV CONNECTION
			● To Connect To A TV With AV Input Terminals . . .
Cord
			a– Connect the aerial, recorder and TV as per "RF
			CONNECTION".
			b– Connect an optional AV cable between the
			AUDIO OUT and VIDEO OUT connectors on the
			rear panel of the recorder and the TV's AV-IN
			terminals .
			CONNECT RECORDER TO
	Rear View	4	MAINS
			Plug the end of the mains power cord into a mains
Mains outlet	AUDIO OUT/		outlet.
	VIDEO OUT		NOTE:
	Connect the power plug to an AC		Use the conversion plug (not provided in certain areas)
			depending on the type of your AC wall outlet.
	outlet before installing the lithium
	battery. ☞ pg. 5
		ATTENTION
		If you have finished all the necessary connections, go to
		"Video Channel Set" on page 4, then perform Auto Set Up on
		page 6; do NOT press the		button on the recorder/remote
		control to turn on the recorder's power before you start Auto
		Set Up.