JVC HR-J6004UM, HR-J4004UM instruction manual Auto Tuner Set, During Plug & Play

INITIALSETTINGS

5

Plug & Play

Auto Tuner Set

ª £

q 2 5/8 3

IMPORTANT

●Don't press any buttons on the VCR or remote while Plug & Play is in progress.

●If you perform Plug & Play successfully, there's no need to perform the Tuner procedures (☞ pg. 8). If, however, you want to add or delete channels, refer to "Add Or Delete A Channel" on page 10.

The Plug & Play function sets the tuner channels automatically when the POWER button is first pressed to power on the VCR after you connect the power plug to an AC outlet.

1	PLUG & PLAY SETUP
	Connect the antenna cable to the VCR (☞ pg. 4). Then
	connect the VCR's power plug to an AC outlet.
2	TURN ON THE VCR
	Press POWER. The tuner channels will automatically be set.
	● The auto channel set function scans all the channels
	that are receivable by your VCR. It then automatically
	assigns each receivable channels to the CH5°
	buttons. It skips non-receivable channels. During
	auto channel set the channel numbers are displayed
	as they are scanned and set.
	● After you perform Plug & Play, if the tuner channels
	have not been set properly or if "SIN SEÑAL" is
	displayed on screen, make sure that the antenna
	cable is connected to the VCR properly and turn off
	the VCR power once, then turn the power back on;
	the VCR will try Plug & Play again.
3	RETURN TO NORMAL SCREEN
	Press MENU as many times as necessary.

AJUSTE AUTOMATICO	AJUSTE AUTOMATICO
DE CANALES	DE CANALES

On-Screen Display

EXPLORANDO ... FIN DE EXPLORACION

PRESIONE (MENU) P/TERMINAR	PRESIONE (MENU) P/TERMINAR
During Plug & Play	When Plug & Play is completed, the lowest
The channel numbers are displayed as	position number will appear on the front
they are scanned and set.	display panel.

Front Display Panel

Be sure to connect the power plug to an AC outlet first before installing the lithium battery; otherwise, the battery's service life will be drastically shortened.

Installing/Removing the lithium battery

1Make sure that the power plug is connected to an AC outlet and turn off the VCR power.

2Open the battery cover while pressing the release tab as illustrated.

3Insert a lithium battery with the plus (+) side up and push it in.

●To remove the lithium battery, press the latch A down- ward using a pointed non-metallic object, then pull out the lithium battery.

4Close the battery cover until it clicks in place.

A