JVC HR-J249EE, HR-J448EE, HR-J245EE, HR-J248EE specifications Regarding Guide Program Number Set

1 2 3

4 5 6

NUMBER

7	8	9
	0
2
1	3	Á
¦	7	8
1	4	¢
MENU		PUSH JOG
3

EN21

NOTES:

● You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen. To record the extra programme, you must first cancel any unnecessary programmes (☞ pg. 24, "Check And Cancel Programmes").

● In case of a power failure after programming, the recorder’s memory backup keeps your selections (if the lithium battery is not exhausted).

ATTENTION

Regarding Guide Program Number Set

"ERROR=GUIDE PROG" appears after performing step 3 on the previous page if the Guide Program number for the SHOWVIEW number you entered has not been set.

● If the recorder is in the stop or rewind or fast-forward mode, the following screen will appear with "– –" under "TV PROG" blinking.

• Press the NUMBER keys or PUSH JOG %Þto input the channel position number you recorder receives that station on, then press OK.

OK

SHOWVIEW SET-UP

GUIDE PROG	TV PROG
2	– –

[0-9] OR [5/°] : SELECT =

[MENU] : EXIT

(Ex.) To timer-record a RTR programme with SHOWVIEW

*If your recorder receives RTR on the channel position 2, press OK after entering "2".

• Press MENU, then try again from step 1.

●If the recorder is in a mode other than the above mentioned modes, press MENU first and input the correct Guide Program number for that SHOWVIEW number (☞ pg. 18, "SHOWVIEW Setup"), then try again from step 1.