JVC HR-J548E, HR-J748EH specifications Satellite Tuner Users, Press OK

EN27

SET TAPE SPEED

4 Press SP/LP ( ) to set the tape speed.

	5	RETURN TO NORMAL SCREEN
		Press OK.
q
		● Repeat steps 1–5for each additional programme.

TIMER						ENGAGE RECORDER’S TIMER
						MODE
		TIME				6 Press TIMER. The recorder turns off automatically.
						NOTE:
		ADD
						To Delay The Stop Time . . .
		2				. . . press ADD TIME (NUMBER Key "5") after pressing OK in
						step 3. Each time you press, the Stop time is delayed by 5
	1	2	3
						minutes (meaning that 5 minutes of recording time is added).
NUMBER	4	5	6			You can easily compensate for anticipated programme schedule
						delays this way.
					WEEKLY
	7	8	9			To Timer-Record Weekly Or Daily Serials . . .
		0		4	TIMER	. . . after pressing OK in step 3, press WEEKLY (NUMBER key
CANCEL						“9”) for weekly serials or DAILY (NUMBER key “8”) for daily
		DAILY				serials (Monday–Friday). Either "WEEKLY" or "DAILY" appears
						on the screen. Pressing the button again makes the correspond-
						ing indication disappear.
SP/LP						You can programme this recorder to timer-record as many as 8
						programmes. If you try to programme the recorder to record a
						ninth, "PROGRAM FULL" appears on screen and "FULL" appears

on the front display panel. To record the extra programme, you must first cancel any unnecessary programmes (☞ pg. 30).

3 OK

MENU 1

PUSH JOG

Satellite Tuner Users

To timer-record a satellite broadcast using SHOWVIEW, perform steps 1 – 6 and, before the selected programme begins, select the appropriate channel on the satellite tuner. Then set the tuner's timer. If your satellite tuner doesn't have a timer, leave the unit's power switched on.

ATTENTION

Regarding Guide Program Number Set

"ERROR=GUIDE PROG" appears after performing step 3 on the previous page if the Guide Program number for the SHOWVIEW number you entered has not been set.

●If the recorder is in the stop or rewind or fast-forward mode, the following screen will appear with "– –" under "TV PROG" blinking.

•Press the NUMBER keys or PUSH JOG %Þto input the channel position number you recorder receives that station on, then press OK.

GUIDE PROG SET

			(Ex.) To timer-record a ZDF
GUIDE PROG		TV PROG	programme with SHOWVIEW
			* If your recorder receives
	2	– –	ZDF on the channel
			position 2, press OK after
			entering "2".
[5°] =
[MENU] : EXIT

• Press MENU, then try again from step 1.

●If the recorder is in a mode other than the above mentioned modes, press MENU first and input the correct Guide Program number for that SHOWVIEW number (☞ pg. 10, "SHOWVIEW Setup"), then try again from step 1.