JVC HR-J748E Select NEW Station, Switch Stations, Select Station Name Character, Fine-Tune

Perform steps 1 and 2 of "Storing Channels Manually" on page 40 to access the Confirmation screen before continuing.

Set Stations (A)

1	SELECT ITEM
	Press PUSH JOG%Þ%%until the item you want begins
	blinking. Then press OK twice and the station’s name
	(ID) begins blinking.

2	SELECT NEW STATION
	Press PUSH JOG%Þ until the new station’s name (ID)
	you want to store begins blinking.
	Registered station names (☞ pg. 42) appear as you
	press PUSH JOG%Þ.

3	SWITCH STATIONS
	Press OK.
	● Repeat steps 1 through 3 as necessary.
	CLOSE CONFIRMATION
4	SCREEN
	Press MENU.

Set Stations (B)

NOTE:

First perform step 1 of the above procedure.

SELECT STATION NAME CHARACTER

Press PUSH JOG%and the first letter of the station
2 name begins blinking.
ENTER NEW CHARACTER
Press PUSH JOG to cycle through the characters
%Þ			%
*	]
(A–Z, 0–9, –, , +,		(space)) and stop when the
3 desired one is indicated, then press PUSH JOG				to
enter. Enter the remaining characters the same way
(maximum of 4).
After entering all characters, press OK.

●Repeat steps 1 through 3 as necessary.

● If you make a mistake, press PUSH JOG% until the incorrect character begins blinking. Then enter the correct character by pressing PUSH JOG%Þ .

CLOSE CONFIRMATION SCREEN

4 Press MENU.

EN41

Fine-Tuning Channels

Already Stored

		SELECT CHANNEL TO
1		FINE-TUNE
		Press PUSH JOG %%until the channel you want to
	%Þ
	tune begins blinking.
		ACCESS MANUAL CH. SET
2		SCREEN
		Press OK three times. The Manual Ch. Set screen
		appears.
3		PERFORM TUNING
		Press PUSH JOG until the picture is its clearest.
	%Þ
	Then press OK.
		● The Confirmation screen appears.
		● Repeat steps 1 through 3 as necessary.
		CLOSE CONFIRMATION
4		SCREEN
		Press MENU.