14 | Editing |
NOTES:
●The B.E.S.T. system works only after a tape has been inserted and the Record mode is first initiated. It does not work during recording.
●Once the cassette is ejected, the B.E.S.T. data is cancelled.
The next time the cassette is used for recording, B.E.S.T. is
ATTENTION:
Since the B.E.S.T. system works before recording actually starts, there is a delay of approximately 7 seconds after 7 and $ on the remote are pressed, or 7 on the player is pressed.
To make sure you record the desired scene or programme in its entirely, first perform the following steps:
1 Press and hold 9 and 7 to engage the Record Pause mode.
•The player then automatically check the condition of the tape and, after approximately 7 seconds, reenters
Record Pause.
2 Press $ to start recording.
•If you want to bypass the B.E.S.T. system and begin recording immediately, set “B.E.S.T.” to “OFF”.
Playback
The video cassette player assesses the quality of the tape once you initiate playback. When watching a tape recorded with B.E.S.T. set to on, it is recommended that you leave B.E.S.T. on during playback as well.
8The player adjusts the playback picture quality based on the quality of the tape
in use.
8B.E.S.T. is active during Auto Tracking.
NOTE:
When watching a rental tape, or one recorded on another video player, set B.E.S.T. to on or off to your preference.
Editing
Editing To/From Another Recorder
Player
IN OUT
ANT.IN
AUDIO
VIDEO
RF OUT
Recorder | Audio/Video signals |
|
IN OUT
ANT.IN
AUDIO 
VIDEO 
RF OUT |
TV VIDEO
Receiver CHANNEL
AConnect the player’s AUDIO and VIDEO
OUT connectors to the recorder’s AUDIO and VIDEO IN connectors.
BPut the player in the Play mode. CPut the recorder in the Record mode.
NOTES:
●NTSC tapes being played back in the NTSC PLAYBACK ON PAL TV mode cannot be dubbed to another recorder.
●When you dub an NTSC tape using your recorder as the playback deck, select NTSC 3.58 (or 4.43) with the Colour System Output switch.
Important:
8To edit, both the player and the recorder must be of the same colour
system. Set “NTSC ”to appropriate mode. (See “Mode set” pg. 9)
