JVC HR-P111AG, HR-P110AG, HR-P110AS instruction manual Mode Description, Press Colour System

10 Setting Of The Colour System Select Buttons

Setting Of The Colour System Select Buttons

Use the COLOUR SYSTEM button on the front panel to select the colour system. Pressing the COLOUR SYSTEM displays the current setting on the screen. While the current setting is displayed, press COLOUR SYSTEM again to change the mode as illustrated below. The On-Screen display will show which mode is selected.

●If the mode is changed between different types of colour signals, the picture might be distorted at the switching point.

* Appears during playback only.

Mode	Description
AUTO	Usually set to this mode. This
	mode automatically detects PAL,
	NTSC 3.58, MESECAM and adjusts
	to the colour system being
	recorded or played back.
	When it does not perform properly,
	set the colour system manually.
MANUAL	For recording, there is a choice of 4
	selectable modes; NTSC 3.58/
	NTSC 4.43/PAL/MESECAM. Select
	the mode that matches the colour
	signal being received.
	For playback, there is an additional
	mode which allows NTSC tapes to
	be played back and viewed on PAL
	TVs.
	To record an NTSC 4.43 signal,
	perform the following steps,
	A Press and hold 9, and press 7
	to enter Recording Pause
	Mode.
	B Press COLOUR SYSTEM
	repeatedly and select NTSC
	4.43 colour mode.
	C Press $ to start recording.

NOTES:

●In the AUTO mode, NTSC signals will be automatically recorded as NTSC 3.58.

●In the AUTO mode, NTSC tapes will be played back as NTSC 3.58.

●SECAM signals will always be recorded as MESECAM. Select the AUTO or the MESECAM mode when recording SECAM signals.

●When playing back a SECAM tape, select the AUTO or MESECAM mode. The playback picture will always be monochrome.

●In the NTSC 4.43 mode, with some TVs, on-screen displays (Program screen etc.) may roll up or down and there may be a loss of colour. When this happens, select the AUTO mode.