JVC HR-P110AS Setting the video channel, BSet video channels, CPress OK, DSet TV system

8 Setting the video channel

Setting the video channel

To watch videos on your TV, it must be set to the same UHF channel as the video cassette player. This channel is used as the video channel.

This video cassette player has been preset to UHF channel 36.

NOTE:

When you have connected the VIDEO/AUDIO OUT terminals of this video cassette player to your TV’s video/audio in terminals (connection B of the “Connections” section), setting the video channel is not necessary. In this case simply set the TV’s TV/VCR switch to VCR.

IMPORTANT:

Before performing the following steps, make sure the player's power is off and there is no cassette inserted in the player.

AAccess video channel set mode.

Hold down 0 on the video cassette player until both of the POWER-ON and STANDBY/REC indicators light.

BSet video channels.

Set your TV to UHF channel 36.

●If the two vertical white bars appear clearly on the screen as shown in the illustration on the right, go to step 3.

●If the two vertical white bars do not appear clearly, press TRACKING + or

– to set the video cassette player to a vacant channel between 32 and 40 which is not occupied by any local station in your area.

●The mode indicators tell channel position.

The indicators blink different speed by the channel position as shown on the right.

CPress OK/ .

●STANDBY/REC indicator goes off.

DSet TV system.

●Set “RF OUT” to “B/G” or “D/K”. (See “Mode set” ( pg. 9))

POWER-ONSTANDBY/REC

POWER ON	STANDBY/REC
indicator	indicator
TEST SIGNAL:
	The channel on
	which the screen to
	the left appear
	clearly in step 2 is
	your Video Channel.

To view picture signals from the video player, set your TV to the Video Channel.

CH	POWER-ON	STANDBY/REC	Blinking
	(green)	(red)	Speed
40	-	blink	fast
39	-	blink
38	-	blink
37	-	blink	slow
36	light	light	-
35	blink	-	slow
34	blink	-
33	blink	-
32	blink	-	fast