JVC HR-S5900U DBS Receiver Brand Setting, 54 EN, Turn on the DBS receiver, Operate DBS receiver

54 EN MULTI-BRAND REMOTE CONTROL (cont.)

DBS Receiver Brand Setting

This Remote can control some functions of the DBS (Direct1Broadcast Satellite) receivers listed below.

Turn on the DBS receiver

Turn on the DBS receiver using the Power button

2on the DBS receiver or its Remote.

Enter DBS receiver brand code

1Follow the example shown below.

2–14

POWER

2Press and hold CABLE/DBS.

3Press MBR SET.

Press the Number keys to enter your DBS

receiver’s brand code by referring to the table

CABLE/DBS

1 2 3

4 5 6

7 8 9

0

2

4

2–2

2

–3

Number

4below.

Press OK, and release CABLE/DBS.

The DBS receiver should turn off. If it does, try

other operations below ( step 3).

●Once you have set the Remote to operate the DBS receiver, you do not have to set it until you

3replace the batteries from the Remote.

Operate DBS receiver

1

3 –4

ENTER

TV CH +/–

While holding down CABLE/DBS, press one of the following buttons: POWER, TV CH +/–, and Number keys.

●For some brands, you must press ENTER after having pressed the Number keys to enter a channel number.

●To change the DBS receiver’s channels, press TV CH +/– or the Number keys. (The CH +/– button can be used to change the VCR’s channels only.)

DBS BRAND NAME	BRAND CODE
JVC (DISH Network)	51
ECHOSTAR (DISH Network)	51
PRIMESTAR	50
SONY (DSS)	41
RCA (DSS)	40

NOTES:

●Depending on the type of DBS receiver, some or all functions cannot be operated using this Remote.

●It’s not possible to operate a DBS receiver not equipped with a remote sensor.

●It's not possible to set the Remote for both your DBS receiver and a cable box at the same time. You can only set the Remote to operate one of these units at a time.

(Ex.) To set the Remote to JVC 51:

CABLE/	MBR SET
DBS	A/B		E
			NTER/O
	5	1		SD	Release
			3	OK
Hold	Press in succession
down