JVC HR-S5900U, HR-5910U manual Express Timer Programing, 34 EN

34 EN TIMER RECORDING (cont.)

Express Timer Programing

Turn on the VCR and the TV, and select the VCR channel 3 or 4 (or AV mode) on the TV.

You can directly program the VCR’s timer to record up to 8 broadcasts, as far as a year in advance. Remember, the clock must be set before you can program the timer (
pg.18 or 10).

Load a cassette

Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load it into the VCR.

●The VCR turns on, and the counter is reset,

2automatically.

Access VCR PLUS+ screen

3Press PROG..

Access Program screen

POWER

1 2 3

2

4 5 6

329DAILY54 98076

7 8 9WEEKLY

04

Press START +/– once. (If no program is stored, “PROGRAM 1”

4appears.)

PROGRAM 1

START		STOP
– –:– –AM	=	– –:– –AM
DATE		CH
– –/– –/– –		– – –	SP

PRESS (+/–, SP/EP, 8=DAILY,

9=WEEKLY), THEN (0K) PRESS (PROG.) TO END

Set program start time

1

Press START +/– repeatedly to enter the time you want recording to start.

●Press and hold START +/– to increase the time in 30-minute

5intervals.

PROGRAM 1

START		STOP
8:00 AM	=	– –:– –AM
DATE		CH
– –/– –/– –		– – –	SP

PRESS (+/–, SP/EP, 8=DAILY,

9=WEEKLY), THEN (0K) PRESS (PROG.) TO END

Set program stop time

Press STOP +/– repeatedly to enter the time you want recording to stop.

●Press and hold STOP +/– to increase the time in

630-minute intervals.

Set program date

Press DATE +/–. (The current date is displayed on the screen. The date you enter appears in its

7place.)

Set channel number

Press CH +/–.

●If you are using a DBS receiver, see “ATTENTION FOR DBS RECEIVER USERS” on next page.

●Holding down CH +/– rapidly changes the channel numbers.