52advanced features

Editing Using Another VCR

connect up Connect the player’s 21-pin SCART connector to the recorder’s 21-pin SCART connector as illustrated.

AWhen using your VCR as the player ...

... connect its AV1 (L-1) IN/OUT connector to another VCR.

BWhen using your VCR as the recorder ...

... connect its AV2 (L-2) IN/DECODER or AV1 (L-1) IN/OUT connector to another VCR.

If another VCR is compatible with Y/C signal ...

... When using your VCR as the player, set L-1 OUTPUT to S-VIDEO( pg. 48).

... When using your VCR as the recorder, set L-2 INPUT to S-VIDEO( pg. 49).

set vcr’s input mode The recording VCR mode must be set to AUX. If this VCR is the recorder, press AUX and/or PR to select L-1(if you’ve used the AV2 (L-2) IN/DECODER connector) or L-2(if you’ve used the AV1 (L-1) IN/OUT connector). If this VCR is the player, set O.S.D. to OFF. ( pg. 55)

•When using the AV2 (L-2) IN/DECODER connector, set L-2 SELECT to the appropriate mode. ( pg. 51)

set edit mode See Picture Control on page 33.

start source vcr Engage its PLAY mode.start recording vcr Engage its RECORD mode.

NOTES:

•All necessary cables can be obtained from your dealer.

•For Y/C signal input/output, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.

•When you set PICTURE CONTROL to EDIT to dub tapes ( pg. 33), be sure to select AUTO (or NORM when B.E.S.T. is set to OFF) after you finish dubbing the tapes.

•If you are using another VCR with S-Video and Audio input/output connectors, you can connect those connectors to this VCR’s S-VIDEO IN/S OUT and AUDIO IN/OUT connectors.

When using your VCR as the player ...

... connect its rear panel S OUT and AUDIO OUT connectors to the recording VCR’s S-Video and Audio input connectors.

When using your VCR as the recorder ...

... connect its front panel S-VIDEOand AUDIO input connectors to the player’s S-Video and Audio output connectors. Then, set the VCR’s input mode to S-1.