JVC HR-S9400EE specifications Start Editing, END Insert Editing

									EN 45
					INSERT	PLAY	6	ENGAGE INSERT EDITING
								Press INSERT.
								● Your recorder enters the Insert-Pause mode. ("		", "	"
						8		and " " light up on the front display panel.)
								● The TV screen changes from the still picture to the
•	• •	•	•	• •	•			input source you are going to record.
••	• • •	•	• ••	• • •	••
					DUB			START EDITING
					A.			Load the source cassette and play back the segment
								that is to be inserted. When you reach the start of the
							7 section of the source tape that you wish to insert, press
								PLAY to start the tape in your recorder; Insert Editing
								begins at this point.
								● " " and "	" are displayed on the front display
								panel.

			END INSERT EDITING
	2		At counter "0:00:00", Insert Editing will stop automati-
1	2	3	cally while the tape continues running in the Play
			8 mode. If you wish to stop Insert Editing before the
4	5	6	specified edit-out point, press C.RESET.

7 8 9

FOR AV INSERT EDITING

C.RESET

04

If you want to replace the picture, Hi-Fi audio soundtrack and

PLAY

normal audio soundtrack all at the same time...

In step 6 above, after you press INSERT, press A. DUB also. (" " and " " blink and " " lights up on the front display panel.)

3

1

NOTES:

●Suitable leads can be obtained from your dealer.

●Insert editing is not possible with cassettes whose safety tab has been removed.

●When insert editing is performed on a tape that has been recorded on another video recorder, the inserted portion may appear distorted.

●In insert editing, the recording speed (SP/LP) is determined by the previous recording to be replaced. If the previous recording's speed changes within a single edit, the inserted picture will be distorted at the switching point.

●A small portion of the recording which precedes an insert edit may become erased.

●Insert Editing is also possible using the rear panel AV1 IN/ OUT or AV2 IN connector. When using these connectors, make sure to select the correct input mode in step 2.