JVC HR-S9400EE Access Jlip ID NO. SET Screen, SET Jlip ID Number, Return to Normal Screen

INFORMATIONONJTERMINALEN49

			8
•• • • • ••		•• • • • ••
• •	• •	• •	• •

J terminal

J Terminal (JLIP (Joint Level Interface Protocol) Connector)

The J Terminal is used to connect the recorder to a personal computer or similar device to allow computerized control of the recorder during editing and certain other operations.

Examples:

●Enables Random Assemble Editing of up to 99 segments with the optional JLIP PLAYER PACK, using this recorder as the playback unit.

●Allows you to capture still images from the recorder into a personal computer with the optional JLIP VIDEO CAPTURE BOX.

For further details consult your nearest JVC dealer.

2

1 2 3

4 5 6

7 8 9

04

3 OK

1 MENU

PUSH JOG

ATTENTION

After you change your recorder's JLIP ID number, control signal transmission may not work properly. If this happens, turn off the recorder's power off once, then turn it back on and try again.

JLIP ID Number

Your recorder has its own JLIP ID number. This ID number must be unique when your recorder is connected to another device via its J terminal. The ID Number is preset to "1" at the factory. You can change this number to any number between "1" and "99". If it is necessary to change the JLIP ID number perform the following steps.

ACCESS MAIN MENU

SCREEN

1 Press MENU twice.
	ACCESS JLIP ID NO. SET
	SCREEN
	Press PUSH JOG %Þ and	MAIN MENU
move the highlight bar		MODE SET
2 (pointer) to "JLIP ID NO.
		AUTO CH SET
SET", then press OK.		MANUAL CH SET
		GUIDE PROG SET
		CLOCK SET
		LANGUAGE SET
		JLIP ID NO. SET
		R.A. EDIT
		[5°] =
		[MENU] : EXIT
	SET JLIP ID NUMBER
	Press PUSH JOG %Þ to	JLIP ID NO. SET
enter the desired ID
3 number.
			1
		CLOCK SET
		[5°] : SELECT
		: OK
		[MENU] : EXIT
	RETURN TO NORMAL
	SCREEN
4 Press MENU or OK.