advanced features38
Check Result of Test
If the satellite receiver’s channel number
has been changed to the same channel as
you set ...
Press the PR and PR buttons to move
the highlight bar to CHANGED TO ..., then press
OK button (or ) to finish the Sat Control
Set mode.
If the satellite receiver’s channel number
has not been changed correctly ...
Press the PR and PR buttons to move
the highlight bar to NOT CHANGED, then press
OK button (or ). Then perform the
procedure again from entering the satellite receiver’s brand code.
Notes
• The Satellite Controller may not work with all types of satellite receiver.
• For some satellite receivers, you need to set its channel input mode to 2-digit.
• If your satellite receiver has more than two channel modes, be sure to set to
All Channel Mode. For details, refer to the instruction manual of the satellite
receiver.
• When selecting the satellite receiver’s preset position for testing, signals from
the Remote Control may interfere with signals transmitted from the Satellite
Controller. In this case, move the Remote Control as close to the recorder’s
infrared beam receiving window as possible.
.
F
[1] a k
[MENU]: EXIT
[1] a k
[MENU]: EXIT
F
SAT CONTROL SET
SAT PROG : 111
CHANGED TO 111
NOT CHANGED
HR-V615/616/617EK-EN/p29-42 3/8/04, 10:19 AM38
Black