JVC HR-V615EK, HR-V617EK, HR-V616EK manual Preset Download, Three step quick start

three step quick start

FINISH AUTO SETUP

Press OK button and move on to Step 2 to check the results.

11

oops! If there is a power cut or you accidentally press a button during Auto Setup, turn the VCR off and then on again. Re-perform Auto Setup.

Preset Download

before you start

Check that the VCR is turned off and no cassette is inserted

Load the batterys into the Remote Control

Refer to the Remote Control diagram on pages 6–7

START PRESET DOWNLOAD

Press the obutton. The display panel on the front of the VCR will show the word ‘Auto’. Press the PR and PR button to select ‘CH – –’ and press OK button (or ).

what will happen? The VCR is automati- cally setting up the tuner channels by down- loading from your TV, clock and the VIDEO Plus+ system assigned Guide Program num- bers. During downloading, preset position on the display panel increases from “CH1”.

SAT

VCR

REVIEW

SAT

VCR

REVIEW

Preset Download is running:

don’t touch any buttons

Unless indicated otherwise, use the buttons on the Remote Control

rf and scart connection If the TV set is in its AV mode (see the TV manual), you will see the following information displayed on your TV screen:

Check that the connection is completed

Be sure to use the fully- wired 21-pin SCART cable

Turn on the TV whose channels have already been stored

– –:– –

T-V LINK

PLEASE WAIT

Your TV screen during Preset

[MENU]: EXIT Download

SET THE VIDEO CHANNEL TO OFF
When Preset Download has finished, ‘COM-
		SAT
PLETED’ appears on the TV screen. Press oto
	VCR
turn off the VCR. Press and hold down Son		REVIEW
the VCR until you will see the display on the
right. Press PR --on the Remote Control until the figure reads ‘– –’.

FINISH PRESET DOWNLOAD

Press OK button and move on to Step 2 to check the results.

oops! If there is a power cut or you accidentally press a button during Preset Download, turn the VCR off and then on again. Re-perform Preset Download.

NOTES

•In areas where no TV station transmits the PDC signal, the VCR cannot setup either the clock or Guide Program numbers.

•On this VCR, the characters available for station names (ID) are A–Z, 0–9, –,

*, + and (space). The names of some downloaded stations may differ from those on your TV.

HR-V615/616/617EK-EN/p08-12 11 3/8/04, 10:07 AM

Black