Masterpage:Right-No-Heading

EN 31

Filename [XVS20EX_07S-VHS.fm]
Page 31 February 14, 2003 1:18 pm
ESet the tape speed.
Press SP/LP/EP (p).
●It is not possible to select EP mode if “COLOUR SYSTEM” is
set to “MESECAM”. (墌pg. 74)
FSet the VPS/PDC mode.
Press VPS/PDC (number key “7”) to select “ON” or
“OFF”.
●If “VPS/PDC ON” is displayed on the TV screen, “VPS/PDC” is
set to “ON”.
●If “VPS/PDC OFF” is displayed on the TV screen, “VPS/PDC”
is set to “OFF”.
墌“VPS/PDC Recording” on page 33.
GReturn to the normal screen.
Press PROG or OK. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears.
●Repeat steps B–G for each additional programme.
HEngage the unit’s timer mode.
Press # (TIMER). The unit turns off automatically and
“#” appears on the front display panel.
●To disengage the timer mode, press # (TIMER) again.
NOTES:
●To Change The Stop Time:
— press STOP +/– after pressing OK in step D. You can
compensate for anticipated programme schedule delays.
●To Timer-Record Weekly Or Daily Serials:
— after pressing OK in step D, press WEEKLY (number key
“9”) for weekly serials or DAILY (number key “8”) for daily
serials (Monday — Friday). Either “WEEKLY” or “DAILY”
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
●You can programme this unit to timer-record as many as 8
programmes. If you try to programme the unit to record a
ninth, “PROGRAM FULL” appears on the TV screen and
“FULL” appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes. (墌pg. 34)
●If there is a conflict in the timer schedule and one programme
overlaps with another, the programme starting earlier or
programme with the lower programme number will be
recorded.
Satellite Receiver Users
To timer-record a satellite broadcast using the SHOWVIEW
system:
ASet “L-2 SELECT” to “A/V”. (墌pg. 61)
BPerform steps A–H.
CSet the satellite receiver to the appropriate channel before
the selected programme begins.
DLeave the satellite receiver’s power on.

ATTEN TION

Guide Program Number
“Guide Program number” refers to the assigned TV station
numbers, according to broadcast area, for the SHOWVIEW
timer recording. The Guide Program numbers can be found
in most TV listings.
If the Guide Program numbers are not set properly when you
timer-record a TV programme using the SHOWVIEW system,
the unit will record a TV programme of a different station.
When programming the timer using the SHOWVIEW system,
be sure to check the desired channel is selected correctly.
Set the Guide Program numbers only in the following cases:
●When timer-programming with the SHOWVIEW system, the
channel position, where the station you wish to record is
received on your unit, is not selected.
OR
●When timer-programming with the SHOWVIEW system, “TV
PROG” shows “– –”.
OR
●When you add a channel after Auto Set Up, Preset
Download or Auto Channel Set has taken place.
OR
●When you wish to timer-record a satellite programme with
the SHOWVIEW system.
Guide Program Number Set
APerform steps A–D of “SHOWVIEW® Timer Programming”
(墌pg. 30).
BPress PR +/– to input the channel position number on
which your unit receives the station, then press OK or e
to set the Guide Program number.
CPerform steps E–H.
XVS20EX_07S-VHS.fm Page 31 Friday, February 14, 2003 1:18 PM