JVC HX-Z30 Connecting Speakers, To connect an outdoor AM antenna, Close the speaker terminals

AM antenna Connecting Speakers

1
2		3	4
	ANTENNA		Vinyl-covered wire
AM EXT	AM
	LOOP		(not supplied)
		FM 75
		COAXIAL
	5
AM loop antenna
(supplied)

1If the cords are covered with insulation, remove a short section of insulation at the end of each cord by twisting and pulling it off.

2Press and hold the clamp of the AM LOOP terminals on the rear of the unit.

3Insert the AM loop antenna to the AM LOOP terminals as illustrated.

4Release your finger from the clamp.

5Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

1
2	3
Speaker cords	Speaker cords
(black/blue)	(black/blue)
Speaker cords
	(black/red)
From right	From left
subwoofer	subwoofer
terminal	terminal
From right main	From left main
speaker terminal	speaker terminal

1If the cords are covered with insulation, remove a short section of insulation at the end of each cord by twisting and pulling it off.

2Insert the end of the speaker cord into the

terminal as illustrated.

Match the same polarity: (+) to (+) and (–) to (–).

3Close the speaker terminals.

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

•DO NOT connect more than one speaker to each speaker terminal.

•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

7