JVC HX-Z30 Using Recording Timer, How Recording Timer actually works, Select the preset station

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically.

How Recording Timer actually works

The unit automatically turns on, tunes in to the specified station, sets the volume level to “VOLUME MIN,” and starts recording when the on-time comes. (“REC” and the REC indicator on the display flash just before the on-time. The REC indicator continues flashing while the timer is operating). Then, when the off-time comes (“REC OFF” appears on the display just before the off-time), the unit automatically turns off (standby).

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

•To correct a mistake while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Insert a recordable cassette with the exposed part of the tape down.

2 Press CLOCK/TIMER repeatedly

until “REC” appears on the display. CLOCK

/TIMER

The (Timer) indicator lights up and the REC (Recording Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY TIMER REC

(Daily Timer setting)

Canceled	Clock		TIMER
	setting	(Recording Timer setting)

(The hour digits start flashing.)

4 Set the on-time you want the unit to turn on at.

	E
1) Turn ¢ / 4 to set the hour,	PR SET
then press SET/DISPLAY.

2)Turn ¢ / 4 to set the minute, then press SET/DISPLAY. “SET” appears for about 1 second, then the unit enters off- time setting mode.

SET

/DISPLAY

5 Set the off-time you want the unit to turn off (standby) at.

1)Turn ¢ / 4 to set the hour, then press

SET/DISPLAY.

2)Turn ¢ / 4 to set the minute, then press

SET/DISPLAY.

“SET” appears for about 1 second, then the unit enters preset station selecting mode.

6 Select the preset station.

1)Turn ¢ / 4 to select the band (“TUNER FM” or “TUNER AM”), then press SET/DISPLAY.

“SET” appears for about 1 second.

2)Turn ¢ / 4 to select a preset channel number, then press SET/DISPLAY.

The REC (Recording Timer) indicator stops flashing and remains lit. “OK ” appears on the display for about 2 seconds.

The settings you have done are shown on the display in sequence for your confirmation.

7 Press to turn off the unit STANDBY (standby) if necessary.

3 Press CLOCK/TIMER again.

“TIMER” appears for about 2 seconds, then the unit enters on-time setting mode.

CLOCK /TIMER

•If you want to listen to another source while recording Press REC START/STOP or 7 to stop recording. Without stopping it, you cannot change the source.

•Even if you unplug the AC power cord or if a power failure occurs

Once you set the timer, the timer setting may remain stored in memory for a few days. Check whether or not the timer setting still remains.

25