JVC HX-Z30 manual Using the Timers, Using Daily Timer, How Daily Timer actually works

Using the Timers

There are three timers available—DAILY (Daily Timer), REC (Recording Timer), and SLEEP (Sleep Timer).

• You can set the timers whether the unit is on or off.

Before using the timers, set the clock built in the unit. (See page 9.)

Using Daily Timer

With Daily Timer, you can wake up to your favorite music or radio program.

How Daily Timer actually works

The unit automatically turns on, sets the volume level to the preset level, and starts playing the specified source when the on-time comes. (“DAILY” and the DAILY indicator on the display flash just before the on-time. The DAILY indicator continues flashing while the timer is operating.) Then, when the off-time comes (“DAILY OFF” appears on the display just before the off-time), the unit automatically turns off (standby).

The Daily Timer works everyday automatically. If you do not want to use the Daily Timer, turn it off. (See “To turn on or off Daily Timer after its setting is done” on page 24.) The timer setting remains in memory until you change it.

•	There is a time limit in doing the following steps. If the setting
	is canceled before you finish, start from step 1 again.
•	To correct a misentry while setting the timer, press
	CANCEL/DEMO.

On the unit ONLY:

1 Press CLOCK/TIMER repeatedly

until “DAILY” appears on the	CLOCK
	/TIMER
display.

The (Timer) indicator lights up and the DAILY (Daily Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY TIMER REC

(Daily Timer setting)

Canceled	Clock		TIMER
	setting	(Recording Timer setting)

(The hour digits start flashing.)

2 Press CLOCK/TIMER again.

“TIMER” appears for about 2 seconds, then	CLOCK
the unit enters on-time setting mode.	/TIMER

3 Set the on-time you want the unit to turn on at.

Before you start...

• When using a disc as the source to play:

– Make sure there is a disc on the selected disc tray.

• When using a tape as the source to play:

– Make sure that a tape is in the cassette deck.

1)Turn ¢ / 4 to set the hour, then press SET/DISPLAY.

2)Turn ¢ / 4 to set the minute, then press SET/DISPLAY. “SET” appears for about 1 second, then the unit enters off- time setting mode.

PR

ES

E

T

– Make sure that the tape direction is correct.

• When using an external component as the source to

play:

– Set the timer equipped on the external component to

the same time.

SET

/DISPLAY

4 Set the off-time you want the unit to turn off (standby) at.

1)Turn ¢ / 4 to set the hour, then press

SET/DISPLAY.

2)Turn ¢ / 4 to set the minute, then press

SET/DISPLAY.

“SET” appears for about 1 second, then the unit enters source selecting mode.

23