JVC HX-Z30 Common Operations, Turning On or Off the Power, Setting the Clock, English, adjust the

English

Common Operations

Turning On or Off the Power		3 Turn ¢ / 4 to
		adjust the
To turn on the unit, press (or	STANDBY
		minutes, then
STANDBY/ON on the remote
		press
control) so that the STANDBY lamp
goes off.		SET/DISPLAY.

PR	E
	SET

SET

/DISPLAY

To turn off the unit (standby), press	STANDBY
(or STANDBY/ON on the
remote control) again so that the
STANDBY lamp lights up.

•A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “AM 12:00” immediately, while the tuner preset stations (see page 12) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built in this unit. “AM 12:00” will flash on the display until you set the clock.

• You can set the clock whether the unit is on or off.

On the unit ONLY:

1 Press CLOCK/TIMER.

The hour digits start flashing on the display.	CLOCK
	/TIMER

2 Turn ¢ / 4 to	PRESET
adjust the hour,	SET
then press	/DISPLAY
SET/DISPLAY.
The minute digits start
flashing on the
display.

To correct the hour after pressing	CANCEL
SET/DISPLAY, press CANCEL/DEMO.	/DEMO
The hour digits start flashing again.

To check the clock time while playing a source

Press and hold SET/DISPLAY.

•Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again

If you have set the clock before, press CLOCK/TIMER repeatedly until the clock setting mode is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY TIMER REC

(Daily Timer setting)

Canceled	Clock		TIMER
	setting	(Recording Timer setting)

(The hour digits start flashing.)

•When you unplug the AC power cord or if a power failure occurs

The clock loses its setting and is reset to “AM 12:00.” If this happens, set the clock again.

•The clock may gain or loss 1 to 2 minutes per month If this happens, reset the clock.

Selecting the Sources

Press one of the source buttons—FM/AM, CD 3¥8, TAPE 2 3, and AUX.

When you press one of the source buttons (FM/AM,

CD 3/8, TAPE 2 3, and AUX), the unit turns on and starts playing the source if it is ready.

•To listen to the FM/AM broadcasts, press FM/AM. (See page 12.)

•To play back discs, press CD 3¥8. (See pages 13 – 19.)

•To play back tapes, press TAPE 2 3. (See page 20.)

•To select an external component as the source, press AUX.

AUX FM / AM TAPE CD

9