5
Plug & Play The Plug & Play function sets the tuner channels automatically
when the POWER button is first pressed to power on the VCR
after you connect the power plug to an AC outlet.
Auto Tuner Set PLUG & PLAY SETUP
1
Connect the antenna cable to the VCR (Z pg. 4). Then
connect the VCR's power plug to an AC outlet.
TURN ON THE VCR
2
Press POWER. The tuner channels will automatically be
set.
●The auto channel set function scans all the channels
that are receivable by your VCR. It then automatically
assigns each receivable channels to the CH5∞
buttons. It skips non-receivable channels. During
auto channel set the channel numbers are displayed
as they are scanned and set.
●After you perform Plug & Play, if the tuner channels
have not been set properly or if "SIN SEÑAL" is
displayed on screen, make sure that the antenna
cable is connected to the VCR properly and turn off
the VCR power once, then turn the power back on;
the VCR will try Plug & Play again.
RETURN TO NORMAL SCREEN
3
Press MENU as many times as necessary.
INITIAL SETTINGS
IMPORTANT
●Don't press any buttons on the VCR or remote while
Plug & Play is in progress.
●If you perform Plug & Play successfully, there's no need
to perform the Tuner procedures (Z pg. 8). If, however,
you want to add or delete channels, refer to "Add Or
Delete A Channel" on page 10.
5
/
8
™
£
3
2
q
A
Installing/Removing the lithium battery
1Make sure that the power plug is connected to an AC outlet
and turn off the VCR power.
2Open the battery cover while pressing the release tab as
illustrated.
3Insert a lithium battery with the plus (+) side up and push it
in.
●To remove the lithium battery, press the latch A down-
ward using a pointed non-metallic object, then pull out
the lithium battery.
4Close the battery cover until it clicks in place.
Be sure to connect the power plug to an AC outlet first
before installing the lithium battery; otherwise, the
battery's service life will be drastically shortened.
Front Display Panel
During Plug & Play
The channel numbers are displayed as
they are scanned and set.
When Plug & Play is completed, the lowest
position number will appear on the front
display panel.
AJUSTE AUTOMATICO
DE CANALES
EXPLORANDO ...
PRESIONE (MENU) P/TERMINAR
On-Screen Display
AJUSTE AUTOMATICO
DE CANALES
FIN DE EXPLORACION
PRESIONE (MENU) P/TERMINAR